GBC Thermal Laminator Machine, Fusion 7000L
What we analysed
BVR’s AI bot is continuously reading, learning and evolving to generate reviews.
21,640 reviews
covering
18 products
for the category
Office Presentation Laminators
Experiential insights by users
About GBC Thermal Laminator Machine, Fusion 7000L
Overall Feedback:
69% positive
73% found it easy to operate, while 27% had trouble loading the film
I had to adjust the position of the laminator while feeding the sheet in, and after leveling it, it went in much further and immediately started feeding it into the device.
68% praised the crystal-clear lamination
It is easy to set up and use, and can laminate several documents in under 10 minutes with excellent quality.
64% praised the easy maintenance, while 36% experienced frequent jamming issues
I faced an issue with the machine displaying an E4 error message. The customer service representative advised me to leave the machine off and unplugged for at least an hour to allow it to reset itself.
I wholeheartedly recommend the product.
There are only a few minor issues with the laminator.
The laminator did not last in our office.
66% appreciated the quiet operation, although 34% found it noisy
I noticed that the laminator emitted a loud beeping noise and the display flashed a yellow line in a circular pattern for a few seconds before changing to E4. This indicates that the noise level is high.
Rephrased: The laminator emitted a loud beeping noise and the display flashed a yellow line in a circular pattern for a few seconds before changing to E4, indicating a high noise level.
I experienced a jam in the laminator after 20 laminations.
66% praised the smooth paper feeding, while 34% experienced paper jams
I noticed that the laminator jammed after 20 laminations, indicating a problem with the paper handling of the laminator.
The laminator jammed after 20 laminations, indicating a problem with its paper handling.
I had to spend half an hour finding out that someone else had jammed the laminator and another hour pulling out the jammed paper.
I had a paper jam in the first laminator and it was not fixable.
63% liked the compact design, but 37% found it too bulky
I suggest regularly cleaning the rollers of the laminator with a cleaning card or sheet of paper.
I received a used laminator that was jammed up and I had to spend an hour to remove the jammed paper.
70% liked the consistent heat settings, but 30% experienced temperature fluctuations
The laminator heats up in about a minute and then it is ready to go.
I had to spend two hours fixing the laminator because someone else had jammed it. This indicates that the thermal performance of the laminator is not good.
