Basswood Sheets for Crafts 1/8 inch, 3mm Plywood Sheets
What we analysed
BVR’s AI bot is continuously reading, learning and evolving to generate reviews.
6,541 reviews
covering
47 products
for the category
Unfinished Wood
Experiential insights by users
About Basswood Sheets for Crafts 1/8 inch, 3mm Plywood Sheets
Overall Feedback:
79% positive
76% found the dimensions accurate, while 24% faced problems
This brand of unfinished wood is layered and warped, whereas the other brand is solid and flat, indicating poor dimensional accuracy.
I received boards that were not quite square and they warp easily.
Every board was warped and cannot be straightened out.
Some of the wood had putty filling on it, making it unusable for lasering.
69% appreciated the grain pattern, but 31% found it uninteresting
Unfinished wood works well with the laser as long as I hold it flat and the project doesn't require a perfectly square board.
I compared the quality of two brands and found that one has layered wood and is warped while the other is solid wood and laid flat.
The wood appeared fine initially, but when I tried to use it in my laser, it became clear that it was warped.
Out of a package of 10, 4-5 pieces have a noticeable bow to them and the wood tends to warp.
Show more
68% appreciated the moisture content, yet 32% experienced issues
I did not mention anything about moisture content of unfinished wood.
I noticed that lasers have difficulty going through some glues and putty, indicating that the unfinished wood may have high moisture content.
Lasers have difficulty going through some glues and putty, suggesting high moisture content in the unfinished wood.
When I opened the product, I noticed that the sheets were light in weight and measured less than 3mm in thickness.
The only complaint is that the wood warps.
Show more
68% praised the sanding quality, though 32% found it rough
Half of the boards are caked in glue and it's not worth the effort to remove it.
My only complaint is that the wood warps, which can be inconvenient when laser cutting as the laser mechanism can hit the middle of the board.
More than half of our boards were warped, some pretty severely.
Every board was warped, indicating poor quality of the unfinished wood.
73% praised the wood quality, while 27% found it lacking
I compared the wood quality of two different brands and found that one brand is layered wood and warped, while the other is solid wood and laid flat.
At first, the wood looked fine, but when I tried it in my laser, it became clear that it was warped.
Every board was warped and could not be straightened.
I have found the wood quality to be inconsistent while using it on my laser engraver.
Show more
