XNEONLab 12 Pack Basswood Sheets for Crafts-12 x 12 x 1/8 Inch- 3mm Thick Plywood Sheets
What we analysed
BVR’s AI bot is continuously reading, learning and evolving to generate reviews.
6,541 reviews
covering
47 products
for the category
Unfinished Wood
Experiential insights by users
About XNEONLab 12 Pack Basswood Sheets for Crafts-12 x 12 x 1/8 Inch- 3mm Thick Plywood Sheets
Overall Feedback:
71% positive
68% found the dimensions accurate, while 32% faced problems
The item was slightly larger than expected, giving me extra room to work with. However, I cannot comment on the dimensional accuracy of the unfinished wood.
Some of the boards cut perfectly with crisp and solid lines, but for two of the six boards, it was like they were made out of a completely different material.
It's difficult to cut with the laser, even with 2 passes, some of it doesn't cut all the way.
72% appreciated the grain pattern, but 28% found it uninteresting
When I pulled the boards out of the package, they looked nice and seemed solid and straight.
It's difficult to cut with the laser and even with 2 passes, some of it doesnt cut all the way. The engraving is also significantly lighter than other basswood.
The pieces being warped is a negative aspect of unfinished wood's grain pattern.
70% appreciated the moisture content, yet 30% experienced issues
About 5 boards were bowed, indicating possible moisture issues, but most were good.
I am unable to cut an entire sheet of this wood without getting an overheat message on my machine due to the higher level of dust generated.
The moisture content of this unfinished wood is high, making it difficult to cut through with a laser and requiring more passes for clean cuts. This has increased our project completion time.
I faced issues with the moisture content of the unfinished wood while using the laser cutter. I had to run the puzzle through the laser on the same settings three times, but it still never completely cut through. Eventually, I had to sand the back and hack out puzzle pieces with an exacto blade, but the puzzle was unusable.
67% praised the sanding quality, though 33% found it rough
I have noticed inconsistencies in the material that make some areas difficult to cut with a laser engraver.
I was disappointed with the 1/8" plywood as it started warping within an hour of taking it out of the box, which I had ready to use in my Laser Engraver.
The pieces are warped and not flat.
Cutting the wood with the laser is difficult.
Show more
69% praised the wood quality, while 31% found it lacking
I received the worst box of wood ever.
The boards are bowed and twisted with inconsistent thickness. The glue used must be different.
