Home > Hot & Cold Water Dispensers > InSinkErator View Instant Hot Water Dispenser System - Faucet & Tank, Satin Nickel, H-View-SN 14.6 x 10 x 8.4 inches ; Visit the InSinkErator Store

InSinkErator View Instant Hot Water Dispenser System - Faucet & Tank

Add to Wishlist
Available on prime

What we analysed
BVR’s AI bot is continuously reading, learning and evolving to generate reviews. How it works?
21,942 reviews covering 58 products for the category Hot & Cold Water Dispensers

Experiential insights by users

About InSinkErator View Instant Hot Water Dispenser System - Faucet & Tank
76% appreciated the large water storage capacity, but 24% found it insufficient
When my unit finally dies due to leakage, I have no choice but to replace it as it would leave a gaping hole in my sink area.
After 3 years, the tank started leaking.
75% liked the modern and sleek design, but 25% found it unattractive
In our new kitchen, the product looks great and replaced the original instant hot water.
The handle on the faucet easily breaks off, indicating a design issue.
I noticed that the handle breaks off easily, indicating that the product design is not up to the mark. The handle breaks off easily, indicating a poor product design.
81% praised for its durable construction, while 19% experienced breakdowns
I have personally observed the durability of the previous model of the heater, which lasted for approximately 9 years despite being used multiple times a day.
I believe the material used inside the hot-cold-water-dispenser should be of better quality.
I have to replace the dispenser to avoid a gaping hole in the sink area as it usually dies by leaking.
The handle of the dispenser breaks off easily.
82% found it easy to operate and clean
Replacing the tank of the instant hot water heater was easy. It took me only 5 minutes to disconnect the three hoses, remove the old unit, install the new unit, and then reconnect the hoses. Another minute to fill the tank with water, plug it in, and I once again have instant hot water.
83% found it easy to install and set up, while 17% had difficulties
I found the installation process pretty easy based on the included instructions.
The installation process was difficult and required several trips to the hardware store to adapt it to fit our current plumbing situations.
Installation may require additional expenses and the help of a plumber.
79% appreciated the quiet operation, while 21% found it noisy
The dispenser is noisy and needs frequent bleeding of air.
I have had three tanks of the product and all of them leaked. It could be related to the noise level of the hot-cold-water-dispensers.
90% appreciated the integrated safety features, although 10% found them inadequate
I have had three tanks, all of which leaked. The repair guy asked if I turned the temperature up, which can stress the tank and cause it to leak. However, I had turned the temperature down to lower the interior steam pressure.
86% praised for its precise temperature control, while 14% found it inconsistent
I turned down the temperature to lower the interior steam pressure after the repair guy warned me that turning it up can stress the tank and cause it to leak.

Buy this product now