Beflog Bottled Water Dispenser Pump System
What we analysed
BVR’s AI bot is continuously reading, learning and evolving to generate reviews.
21,942 reviews
covering
58 products
for the category
Hot & Cold Water Dispensers
Experiential insights by users
About Beflog Bottled Water Dispenser Pump System
Overall Feedback:
75% positive
68% praised for its durable construction, while 32% experienced breakdowns
I am concerned about the durability of the hot-cold-water-dispensers. The components seem good but I can see why reviewers say these things stop working suddenly. They probably just sort of fall apart inside as time goes on.
After using the pump for a year, it has failed and is showing signs of impending failure.
The dispenser suddenly stopped working.
74% found it easy to operate and clean, while 26% had difficulties
The dispenser is easy to install, relatively quiet, and has no leaky fittings. Plus, I can get ice and water at the same place.
The pump is easy to install but noisy. It's also less expensive than others I've seen on Amazon.
I had to use the power switch whenever I wanted water because the pump would keep going even when the faucet was turned off.
74% found it easy to install and set up, while 26% had difficulties
Installation was easy.
I found the pump easy to install and it eliminated the need to pay for bags of ice.
It was very easy to install.
The pump is easy to install but noisy.
72% appreciated the quiet operation, while 28% found it noisy
The dispenser has a good output/flow for basic faucet type use, although it is a little noisy.
I never heard any noise from the pump and never detected any taste or smell from the plastic.
While pumping water into the fridge, the device makes a little bit of noise.
I bolted it down to reduce noise pollution but it did not work.
Show more
65% appreciated the integrated safety features, although 35% found them inadequate
Some safety concerns have been pointed out with the hot-cold-water-dispenser. The assembly of the components inside is an issue, specifically the yellow ground wire from the power cord was attached to one of the components using a small screw and nut, not a compression nut or tooth-lock washer. With the vibration this pump causes when its running, a little screw and nut had no prayer of hanging on. Also, the power switch and some other components are held down only with just a small amount of hot glue. This is not a safe and durable design.
The motor keeps running even when there is no water flowing and it does not turn off.
70% liked the fast and consistent water flow, but 30% experienced slow dispensing
I noticed that the motor runs but there is no water coming out of the fridge. The motor keeps running with no water flowing.
The motor runs but there is no water coming out of the fridge.
