2mm Round Hole Punch Pliers for Sheet Metal Yellow
What we analysed
BVR’s AI bot is continuously reading, learning and evolving to generate reviews.
12,245 reviews
covering
53 products
for the category
Hole Punches
Experiential insights by users
About 2mm Round Hole Punch Pliers for Sheet Metal Yellow
Overall Feedback:
79% positive
64% liked the adjustable settings, while 36% found them confusing
The punch is extremely dull.
The resulting hole is a jagged mess and not clean.
71% appreciated the sturdy build, but 29% didn't
I found the punch to be nice and sharp while punching through.
The hole punch continues to work as expected and is durable.
I noticed that the punch was not properly aligned with the die side and the edge was damaged/rounded over where they hit each other. This resulted in the tool not punching holes cleanly.
The punch was not properly aligned with the die side, resulting in the tool not punching holes cleanly.
I previously used a metal hole punch that was excellent and had no trouble with the same pieces, but I misplaced it.
Show more
79% found it easy to use, however 21% encountered issues
The punch was easy to use and did a great job.
I have noticed that the hole punch struggles to punch through thin pieces.
I noticed that the tool has a manufacturing quality issue and does not punch holes cleanly.
The hole is a jagged mess and not clean.
72% praised the accurate punching, yet 28% found it misaligned
I found the punch to perform very well, easily punching through with its sharpness.
I noticed that the punch was misaligned with the die side, causing damage to the edge where they hit each other. This resulted in an inaccurate punch that only cut about 3/4 of the way around the hole, with the remaining portion bending over.
The hole punch is useless for punching holes in vintage brass stampings.
When I used the hole punch, it got stuck in my metal because it was slightly bent.
63% liked the high sheet capacity, but 37% encountered issues
The hole punch is not working at all as it needs to line up with the hole to work, but it is way out of alignment.
The tool does not punch holes cleanly. It cuts the edge of the hole about 3/4 of the way around and the remaining portion just bends over.
65% appreciated the waste collection, but 35% found it messy to empty
I advise against buying the product for punching anything thicker than aluminum foil.
The hole-punches only worked for one project and then stopped working.
