Waterwood Hand Painted Seahorse Doorbell
What we analysed
BVR’s AI bot is continuously reading, learning and evolving to generate reviews.
8,429 reviews
covering
29 products
for the category
Door Bell Push Buttons
Experiential insights by users
About Waterwood Hand Painted Seahorse Doorbell
Overall Feedback:
78% positive
81% praised the battery life, though 19% desired more
The doorbell button is not seating securely and easily popping out due to pressure from the wires. It could be related to the battery life of the door-bell-push-buttons.
The doorbell button doesn't seat securely and easily pops out due to pressure from the wires. It could be related to the battery life of the door-bell-push-buttons.
83% praised the button durability, but 17% desired more
The seahorse is heavy and well made.
I have complained that securing the button back in place after wiring is difficult and the press fitting is weak, which holds the button in the Seahorse hole.
The doorbell button easily pops out due to the side screw mounting and even a little pressure from the wires pushed into the Seahorse. This negatively affects the button's durability.
84% liked the modern design, though 16% found it outdated
I like that the screws hold the unit in place, unlike other decorative doorbells that just tape on.
I chose this doorbell push button because of its super good reviews and how well it would look with all my other beach decor inside and outside my house in Jamaica Beach, Texas.
Getting the button to seat securely again in the seahorse body after wiring is not easy and it is a weak press fitting that holds the button in the Seahorse hole.
79% found it easy to install, while 21% encountered difficulties
The installation was not too bad, but I had to drill a new hole and provide my own anchor for the brick as the new holes did not line up with the old.
I like that this doorbell has screws to hold it in place and popping out the new button to wire was also easy. However, getting the button to seat securely again in the seahorse body after wiring is not easy.
Getting the button to seat securely again in the seahorse body after wiring is not easy. It is a weak press fitting that holds the button in the Seahorse hole.
71% liked the illumination, but 29% found it dim
The doorbell button does not seat securely and easily pops out due to the pressure from the wires pushed into the Seahorse.
I have complained that the new doorbell button easily pops out due to the side screw mounting and pressure from the wires.
80% appreciated the wireless connectivity, though 20% experienced issues
A better method to secure the bell button in the Seahorse is needed.
