Home > Computer Networking Antennas > Bingfu 4G LTE Outdoor Wall Mount Waterproof Antenna SMA Male Antenna Compatible with Verizon AT&T T-Mobile Sprint 4G LTE Router Gateway Modem Cellular Trail Camera ; Visit the BINGFU Store
Bingfu 4G LTE Outdoor Wall Mount Waterproof Antenna SMA Male Antenna Compatible
Outdoor Wall Mount Waterproof Antenna SMA Male Antenna Compatible,4 G LTE Mobile Router,Mobile Broadband Modem Hotspot,outdoor Security Camera,mobile vehicle Car DVR MDVR Video Record
BVR’s AI bot is continuously reading, learning and evolving to generate reviews.
How it works?
BVR’s AI bot is a smart self learning AI bot algorithm that ingests large amount of data to filter our product reviews that are most important for you to make a purchase
I compared the product with spypoint antenna and found that it gave me two additional bars over this product.
I believe the device has physical limitations and should not be expected to perform beyond them.
70% liked its compatibility with multiple devices, while 30% experienced connectivity issues
I tested the antennas in an area with known signal issues and found an improvement in signal quality. The ping and jitter were lower and the throughput was higher on both upload and download.
I tested the compatibility of the antenna with the modem by comparing the download speed with and without the antenna. I found that the download speed improved by ~50%.
The antennas work great with the spypoint micro lte vzn and come with the required adapter.
If there is no signal to begin with, the antenna cannot provide a strong signal.
I switched to this antenna and got an insufficient signal. I expected to get the same signal, but it did not happen. I tried multiple locations with the same results, always getting no signal with this antenna.
Rephrased: I switched to this antenna and expected the same signal, but got an insufficient one. Trying multiple locations yielded the same result - no signal with this antenna.
70% appreciated the durable and sturdy build, though 30% experienced hardware failure
After adding the antenna and hoisting it up the tree, I consistently got 80% signal strength.
I have been using the antennas for only 3 days.
77% found it easy to set up and install, while 23% encountered difficulties
I have installed 2 of these antennas on my Peterbilt and plugged each one into the 2 ports on an Inseego MiFi 8800L from Verizon.
The TS9 WHY cable fits nicely and tightly.
When I attached the antenna, the signal strength jumped to four bars and then dropped to two.
I have noticed that the signal increase may not always be visible, but it does boost the signal.
67% liked the extended range and coverage, but 33% found dead spots
I noticed that the location and height of the antenna can affect its performance. Moving it a few feet may improve the coverage.
Moving the antenna a few feet can improve its coverage.
I bought this antenna to replace the broken one that came with the Tactacam. I did not buy it to improve cell service/range.
The Spypoint antenna provides two additional bars of coverage compared to this product.
When there is no signal to begin with, the antenna cannot provide a strong signal.
69% praised for its strong signal strength, while 31% experienced dropped connections
Using the antenna increased my 4G LTE home internet router's signal strength compared to using the router alone.
After adding the antenna and hoisting it up 10 up the tree, I consistently get 80% signal strength.
The antenna works, but it is not compatible with our signal meter.
After adding the antenna, my signal strength increased to a steady 90%.
I tested the signal strength of the antennas in an area with known signal issues and found an improvement. I experienced lower ping and jitter and higher throughput on both up and download.
I was unable to upload photos from my trail camera, indicating that the signal strength was not sufficient.
When I attached the antenna, the signal strength increased to four bars but then dropped to two bars. Overall, I had less signal strength with the antenna attached than without it.
After installing the antennas, I noticed that the signal on the two cameras I installed them on has been fluctuating between 50% and 90%, indicating an improvement in the adjustability of the antennas.
Rephrased:
After installing the antennas, the signal on the two cameras I installed them on has been fluctuating between 50% and 90%, indicating an improvement in the adjustability of the antennas.
I adjusted the orientation of the antennas and now consistently have 3 bars. Crossing them into an 'X' pattern was suggested.
Need help? Don't see what you are looking for?
Let us know and our team will start working on your favorite product or category as soon as possible. Meanwhile let us help you search for them on Amazon.
Thanks for your feedback!
Cookies are used on this website to ensure you have the best experience possible.