Timberland Men's 35Mm Classic Jean Belt
What we analysed
BVR’s AI bot is continuously reading, learning and evolving to generate reviews.
55,668 reviews
covering
42 products
for the category
Belts
Experiential insights by users
About Timberland Men's 35Mm Classic Jean Belt
Overall Feedback:
75% positive
68% highlighted the high-quality material, but 32% didn't
I am disappointed with the quality of the belt. The leather split prevented the buckle from clasping on another notch.
The belt is not as expected. The back is made of paper-like material and the leather is made of man-made ground up slurry matrix which may contain leather but will not be durable like real layered leather hide.
The quality of leather is not up to the mark.
The belt I have is made of bonded leather and has low durability.
69% found the fit perfect, but 31% struggled
I like the stretch of the belt.
I cannot fit through the smallest hole, which is at 38.5 inches.
I had to cut a new hole to make the belt snug as it was not fitting me properly.
67% appreciated the stylish design, yet 33% found it plain
The belt's design is not as expected. The back is made of paper-like material and the leather is man-made ground up slurry matrix that may contain leather but will not be durable like real layered leather hide.
64% liked the buckle quality, although 36% experienced issues
I bought this belt around the same time as other brand belts, but unlike them, it did not fray. This indicates good buckle quality.
I bought this belt around the same time as other brand belts, but unlike them, it did not fray.
I noticed that the belt has surface wear and damage where the buckle has cut into the surface of the belt. Additionally, the user mentioned that the buckle did not have the edges of the casting mold polished smooth by the manufacturer so the inside of the buckle has a sharp edge that cuts into the leather.
The belt has surface wear and damage where the buckle has cut into it. Also, the buckle has a sharp edge that cuts into the leather because the manufacturer did not polish the edges of the casting mold.
The outside finish of the belt is peeling and delaminating.
Show more
