Home > Power Drill Chucks > HHIP 1/8~5/8 INCH JT3 Drill Chuck with Key (3700-0105)

HHIP 1/8~5/8 INCH JT3 Drill Chuck with Key

Accurate And Strong Gripping Force., For Portable, Suplied With Chuck Key., Capacity 1/8"-5/8" | Taper Mount Jt3, Bench Or Floor Type Drill Press.

Available on prime
Add to Wishlist
9.3
Created with Raphaël 2.1.29.3010
BVR Rating 159 reviews

Pros

  • Features a portable design that makes it easy to carry
  • Comes with a chuck key that helps in easy operation
  • Equipped with a 5-inch long shank that offers accuracy and strong gripping force

Cons

  • May be stiff

Similar Products

Highlights

Analysis of 100+ reviews for HHIP 1/8~5/8 INCH JT3 Drill Chuck with Key

img-alt

BestViewsReviews analyzed 8,949 reviews for 21 products in the Power Drill Chucks category.

img-alt

We analyzed a total of 159 reviews for this product out of which, 140 reviews were received in the last 6 months.

img-alt

The analysis indicates that around 91% reviews were positive while around 7% of reviews had negative sentiment.

BestViewsReviews Ranking and Score for HHIP 1/8~5/8 INCH JT3 Drill Chuck with Key

img-alt

This product received a total score of 9.34 out of 10, based on review sentiments and user opinions related to 8 features:

  • Build quality
  • Compatibility
  • Customer support
  • Easy to use
  • Longevity
  • Overall satisfaction
  • Size
  • Value for money
  • Users of this product said


    If you want to get the most out of it, you can spend some time with it and blow out any manufacturing gunk, then oil it from top to bottom and work the mechanism until it's good to go.


    If you're looking for a high quality drill press Chuck that's also easy to use, then this is the one to get, it's a taper Chuck and you have to hammer it on to a 5/8 inch shaft if you didn't know already.


    I ordered a new S.B chuck on Amazon, and it looks exactly the same as the one I received from Amazon.


    This drill chuck is made from high accuracy parts not like the OEM chuck on my lower cost drill press.


    I used a small block of 2x to repair the broken spindles on my drill press, and it works great. I went to Advance Auto Parts and rented a ball joint tool kit, which I used to repair the broken spindles on my drill press.

    Question & Answers

    Q:

    What is the length and breadth of this chuck?

    A:

    The Jacobs tapers are 3, with the large end 0.8110 and the small end 0.7461.

    Q:

    Will this fit on the ace 8” 5 speed drill press # 27195c part # 0j2j?

    A:

    The chuck does not screw on to the drill press shaft if it has a pressure fit.

    Q:

    What size chuck will this have?

    A:

    HHIP has many arbors with a 33JT that can be ordered to fit on this 1/2 inch drill chuck.

    Q:

    Which chuck should I buy for my old HILTI TM-7S VSR hammer-drill?

    A:

    We don't offer drill chucks with threaded back holes.

    Q:

    I'm trying to find the best replacement chuck for my ryobi dp 102l 10” benchtop.

    A:

    I used this chuck to replace the stock chuck on the Craftsman 12-INCH BENCH TOP Model No.137.219120 and it operates better and chucks up the smallest bits I own.

    Was this page helpful to you?